Wsm 05-E2B SERIES Especificaciones descargar pdf (Pagina 71)

S-18

03-E2B SERIES, WSM

DIESEL ENGINE

Fan Belt Damage and Wear

1. Check the fan belt for damage.

2. If the fan belt is damaged, replace it.

3. Check if the fan belt is worn and sunk in the pulley groove.

4. If the fan belt is nearly worn out and deeply sunk in the pulley

groove, replace it.

W1020602

CAUTION

• When removing the radiator cap, wait at least ten minutes after the engine has stopped and cooled down.

Otherwise, hot water may gush out, scalding nearby people.

Radiator Cap Air Leakage

1. Set a radiator tester and an adaptor on the radiator cap.

2. Apply the specified pressure 88 kPa (0.9 kgf/cm

, 13 psi), and

measure the time for the pressure to fall to 59 kPa (0.6 kgf/cm

9 psi).

3. If the measurement is less than the factory specification, replace

the radiator cap.

W10387530

Radiator Water Leakage

1. Pour a specified amount of water into the radiator.

2. Set a radiator tester and an adaptor and raise the water pressure

to the specified pressure.

3. Check the radiator for water leaks.

4. For water leak from the pinhole, replace the radiator or repair with

the radiator cement. When water leak is excessive, replace the

radiator.

W10389070

(A) Good (B) Bad

Pressure falling time Factory spec.

More than 10 seconds

for pressure fall from

88 to 59 kPa

(from 0.9 to 0.6 kgf/cm

from 13 to 9 psi)

Radiator water leakage

test pressure

Factory spec.

No leak at 137 kPa

1.4 kgf/cm

20 psi

KiSC issued 05, 2008 A

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 124 125

Comentarios a estos manuales

Sin comentarios

Wsm 05-E2B SERIES Especificaciones Pagina 71

Comentarios a estos manuales

Relacionado con productos y manuales para Motor Wsm 05-E2B SERIES