Wsm 05-E2B SERIES Especificaciones descargar pdf (Pagina 15)

G-3

03-E2B SERIES, WSM

G GENERAL

2. GENERAL PRECAUTIONS

• During disassembly, carefully arrange removed parts in a clean

area to prevent confusion later. Screws, bolts and nuts should be

replaced in their original position to prevent reassembly errors.

• When special tools are required, use KUBOTA genuine special

tools. Special tools which are not frequently used should be

made according to the drawings provided.

• Before disassembling or servicing live wires, make sure to

always disconnect the grounding cable from the battery first.

• Remove oil and dirt from parts before measuring.

• Use only KUBOTA genuine parts for parts replacement to

maintain engine performance and to ensure safety.

• Gaskets and O-rings must be replaced during reassembly.

Apply grease to new O-rings or oil seals before assembling.

• When reassembling external or internal snap rings, position them

so that the sharp edge faces against the direction from which

force is applied.

• Be sure to perform run-in the serviced or reassembled engine.

Do not attempt to give heavy load at once, or serious damage

may result to the engine.

W1011734

(1) Grease

(2) Force

(3) Place the Sharp Edge against the

Direction of Force

(A) External Snap Ring

(B) Internal Snap Ring

KiSC issued 05, 2008 A

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 124 125

Sin comentarios

Wsm 05-E2B SERIES Especificaciones Pagina 15