Wsm 05-E2B SERIES Especificaciones descargar pdf (Pagina 70)

S-17

03-E2B SERIES, WSM

DIESEL ENGINE

(2) Lubricating System

Engine Oil Pressure

1. Remove the engine oil pressure switch, and set an oil pressure

tester (Code No.: 07916-32032). (Adaptor screw size : PT 1/8)

2. Start the engine. After warming up, measure the oil pressure of

both idling and rated speeds.

3. If the oil pressure is less than the allowable limit, check the

following.

• Engine oil insufficient.

• Oil pump defective

• Oil strainer clogged

• Oil filter cartridge clogged

• Oil gallery clogged

• Excessive oil clearance

• Foreign matter in the relief valve

(When reassembling)

• After checking the engine oil pressure, tighten the engine oil

pressure switch to the specified torque.

W1034952

(3) Cooling System

Fan Belt Tension

1. Measure the deflection (A), depressing the belt halfway between

the fan drive pulley and alternator pulley at specified force 98 N

(10 kgf, 22 lbs).

2. If the measurement is not within the factory specifications, loosen

the alternator mounting screws and relocate the alternator to

adjust.

W10356670

Engine oil pressure

At idle

speed

Factory

spec.

More than 98 kPa

1.0 kgf/cm

14 psi

Allowable

limit

49 kPa

0.5 kgf/cm

7 psi

At rated

speed

Factory

spec.

294 to 441 kPa

3.0 to 4.5 kgf/cm

42.7 to 64.0 psi

Allowable

limit

245 kPa

2.5 kgf/cm

35.6 psi

Tightening torque Oil pressure switch

14.7 to 19.6 N·m

1.5 to 2.0 kgf·m

10.8 to 14.5 ft-lbs

Deflection (A) Factory spec.

7.0 to 9.0 mm

0.28 to 0.35 in.

(A) Deflection

KiSC issued 05, 2008 A

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 124 125

Comentarios a estos manuales

Sin comentarios

Wsm 05-E2B SERIES Especificaciones Pagina 70

Comentarios a estos manuales

Relacionado con productos y manuales para Motor Wsm 05-E2B SERIES