Wsm 05-E2B SERIES Especificaciones descargar pdf (Pagina 122)

S-69

03-E2B SERIES, WSM

DIESEL ENGINE

Brush Wear

1. If the contact face of the brush is dirty or dusty, clean it with emery

paper.

2. Measure the brush length (A) with vernier caliper.

3. If the length is less than the allowable limit, replace the yoke

assembly and brush holder.

W1156360

Brush Holder

1. Check the continuity across the brush holder and the holder

support with a circuit tester.

2. If it conducts, replace the brush holder.

W1156895

Armature Coil

1. Check the continuity across the commutator and armature coil

core with resistance range of circuit tester.

2. If it conducts, replace the armature.

3. Check the continuity across the segments of the commutator with

resistance range of circuit tester.

4. If it dose not conduct, replace the armature.

W1156507

Brush length (A)

Factory spec.

15.0 mm

0.591 in.

Allowable limit

11.0 mm

0.433 in.

KiSC issued 05, 2008 A

1 2 ... 117 118 119 120 121 122 123 124 125

Sin comentarios

Wsm 05-E2B SERIES Especificaciones Pagina 122